Running the systems

Running the systems

 

chiftpist

Chift Pist systems are popular amongst the aquaponics DIY sector with many people. Water is pumped from the sump tank into the fish tank, this causes the water level in the fish tank to rise, flowing out into the growbed. The growbed then drains into the sump tank before being pumped back to the fish again. Uses either an autosiphon within the growbed to flood and drain the growbed or run with the growbed constantly flooded.

A SLO (Solids Lift Overflow) is normally incorporated into these systems, This means that the overflow pipe in the fish tank goes right down top the base of the fish tank where it will draw solids upfrom the bottom of the tank and deposit them into the growbed.

Not often set up with timers on the pump unless you have a very large sump as it requires a large capacity to top the fish tank and fill the growbed in a pumping cycle.  Not the simplest method of setting up a system because you have to incorporate a sump tank in your design, but:

Advantages

  • Pump is in sump tank away from fish and wastes
  • Water level in fish tank remains constant
  • Great if you have a tall fish tank
  • Larger water volume because of sump

 

Disadvantages

  • Extra equipment required (sump tank)
  • Must have tall fish tank or stand
  • can take up larger footprint
  • limited running methods (no timer possible)
 

Simple Flood and Drain

 

Simple flood and drain can be done a couple of ways, you can either have a standpipe in the growbed and timer on the pump, or you can use a siphon in the growbed. The debate over which method is better is a hotly debated topic and I think the answer is fairly simple, that each has advantages and disadvantages. Personally after playing with siphons on a few different systems I decided a long time ago that I didn’t want to use them, so all systems I make, use standpipes.

What are standpipes you might ask? This is a standpipe.

A stand pipe next to a drain fitting, then sitting in the drain fitting. By changing the length of the standpipe you can adjust the flooding level in the bed. If you want to flood the growbed to make caterpillars or slugs come up out of your media, then slipping a slightly longer piece of pipe over the end, or just a coupling fitting you can enable the bed to flood, causing all the pests to come up out of the media. If your media level in the bed drops over time then you can cut a little off the stand pipe, lowering the flood level in your bed

There are two small holes in the bottom of the stand pipe, this allows the water to slowly drain out of the bed when the pumps off, hence the flooding and draining action.

Constant Flood

Looks a bit similar to the one above? Yes that’s because it is basically the same as the flood and drain system above, except that when you remove the timer from the system the grow bed remains constantly flooded.

 

Most importantly if this is getting a little confusing for you don’t worry about it, it can be difficult to conceptualize exactly how these things work, if you follow through our simple building and installation steps you’ll be able to build yourself an IBC aquaponic system in no time. If you’d like to learn more about the different methods of setting up and running your aquaponics system, then join the forum, you’ll find lots of information on the forum.

Advertisements

Please leave us your Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s